dagall
02-29-2024, 01:06 PM
Hello, just wanting to get an initial alignment for the PIN drive upper control arm set-up. I have the setting for the upper adjustment which says 9.75 for the front and 8.5 for the rear. Does this apply for the pin drive also or just the standard width?
Mike.Bray
02-29-2024, 02:43 PM
They didn't work for me, not even close. I had to shorten the rear tube by quite a bit to the 7.5 degrees of castor for PS. I can't remember about the front one.
Jeff Kleiner
02-29-2024, 03:08 PM
No, those dimensions are not applicable to pin drive width.
Jeff