Buzzsaw
11-23-2023, 04:30 PM
Hello all,
I have searched then forum for a previous post on my question and did not find any, I must be missing something this question has to be asked before.
My question is what bolts are used to attach the bearing hub assembly to the knuckles? Clearly the are 4 attachment points but I can’t find any information on the bolts or where to find them in the manual. I looked in the special instructions on the FFR web site and found the same information that’s in the manual The manual just shows a picture of the left hand knuckles and then. it says to slide the spindle on the CV joint and use the nut on the end to attach. Any help would be greatly appreciated!
Ross
I have searched then forum for a previous post on my question and did not find any, I must be missing something this question has to be asked before.
My question is what bolts are used to attach the bearing hub assembly to the knuckles? Clearly the are 4 attachment points but I can’t find any information on the bolts or where to find them in the manual. I looked in the special instructions on the FFR web site and found the same information that’s in the manual The manual just shows a picture of the left hand knuckles and then. it says to slide the spindle on the CV joint and use the nut on the end to attach. Any help would be greatly appreciated!
Ross