Engine ground

[Bill Elliott]

Just wanted to see if this engine ground is ok. I used to same chassis bolt to take care of battery , starter mounting bolt, and engine block . 191982

[i.e.427]

See that hole in the pedestal for the passenger side engine mount? One guess why Factory Five puts that hole there. Centralizing your ground locations is always a good idea. Where you have it will work just fine.

Frank

[Bill Elliott]

See that hole in the pedestal for the passenger side engine mount? One guess why Factory Five puts that hole there. Centralizing your ground locations is always a good idea. Where you have it will work just fine.

Frank

Thanks Frank. I had already had the starter and battery grounded there , when I was about to put the engine ground strap on I figured since I had that location already set up to put it there also instead of the engine mounting ears.

[CraigS]

Make sure all paint is removed from the frame tube. Coat the frame and all the wire ends w/ grease. I like to tighten the bolt to where the wire ends are a little snug, and then grab each one and rotate it maybe 45 degrees a few times, then do a final tightening.

[Bill Elliott]

Make sure all paint is removed from the frame tube. Coat the frame and all the wire ends w/ grease. I like to tighten the bolt to where the wire ends are a little snug, and then grab each one and rotate it maybe 45 degrees a few times, then do a final tightening.

Already removed all paint from the 4 inch tube and the engine block. Will put some grease on there :D