Gen 3 Coyote Valve Cover Hoses

[Junbug]

I have a question, and I apologize in advance if its been asked and answered already. I have a gen 3 coyote, complete kit and I'm referencing the 3/23/2020 Revision 1B manual from FFR.
The manual shows the two pictures below but no further instructions as to if/how to connect these two connectors, assuming they need to be connected.
https://thefactoryfiveforum.com/attachment.php?attachmentid=189446&d=1693191917
https://thefactoryfiveforum.com/attachment.php?attachmentid=189445&d=1693191917
And even more confusing, the second pic shows the silicone air intake with a fitting/connection on the bottom side, that the one shipped to me from FFR doesn't have. As seen in the pic below.
https://thefactoryfiveforum.com/attachment.php?attachmentid=189438&d=1693190833
Any advice assistance would be appreciated.
Thanks,
-Bryan

[edwardb]

Agreed the FFR instructions are a little unclear and incomplete. You're dealing with two different things here. The first picture from the instructions is a vacuum line. The second is part of the PCV system. For the PCV setup and assuming a closed system (some will plumb them open) the right side hose goes to the connection by the throttle body. The left side goes to a connection on your air intake. If your intake tube doesn't have a connection, one can be installed pretty easily. For the vacuum system, I explained that in some detail in this post from my Coupe/Gen 3 Coyote build: https://thefactoryfiveforum.com/showthread.php?26630-Edwardb%92s-Gen-3-Type-65-Coyote-Coupe-59-Build-5-000-Mile-Report&p=351623&viewfull=1#post351623.