Help

[jose luis]

Gents,

I have a 93 Grand Marquis rear end that have the same spec. of the 86-93 mustang GT rear end. ( 8.8", disk brakes, 59.25" hub to hub )
I cut all the supports and I need to weld the 2 supports that hold the new that are included in the kit, but I need to know the distance between the 2 supports, center to center too do that.

I appreciate if somebody give to me the measure that I need.
in a att. there are a drawing.

Tks a lot
Jose


7120

[ehansen007]

41 5/8 center to center for me.

[jose luis]

ehansen007
Tks a lot for your post.......When I read the distance between supports of 41" 5/8" that you send to me I knew that there was something wrong with my grand marquis rear end.

When I take the distance hub to hub I made a mistake because I take the distance between plate to plate not hub to hub, so the rear end is 4 inch large than the 86-93 mustang GT, then I need to cut the housing 4 inch, 2" both side and get another shafts.

That work will be done when the kit arrives at home and present the rear end to the chasis and check the distance that you sent to me.

My best regards.