Mastertech5
04-30-2023, 08:55 PM
The AC/Heater kit I got is basically the same as in the pdf instructions except for a couple of things. The 4 condenser mounting brackets look all the same except 2 of them are bent at slight angles and also have a small hole in them. The other 2 are bent straight and have what might be called a T cut through them. There are no funny shaped ones as shown in the instructions and the lower tabs on the condenser are higher up so the "funny looking" brackets aren't needed as previous versions did. There are no pipes to put on as they are molded directly to the condenser. The other thing is that hood hinge mount plates in the picture it says to put on are nowhere to be found. Probably for a Gen 1. My hood hinges don't have anything that looks like that that I can find. The pdf instructions haven't changed since I downloaded them last year. When parts and procedures change they should be changed in the online instuctions/manual. So which brackets go where and what sides do the ones with the holes in them go?? Anyone contacted FFR Tech about this? Frustrated and puzzled. Bruce. See next post.