Part Identification Help

[ekoffman]

Can someone tell me where these are used? Maybe a pic reference if possible? Thanks!177409

[egchewy79]

maybe blockoff plates for the fuel sender and pickup, but I don't recall having holes predrilled in mine. the pickup blockoff was also oval, not rectangular.

[edwardb]

One of the rectangular pieces is a patch panel for where the RH fuel tank strap goes through the trunk floor. In the manual. I think the square one is to plug a hole in the LH floor/transmission tunnel side. Apparently the hole was required for donor builds. But the panel pictured in the manual is a slightly different shape. Not sure about the second rectangular piece. I wouldn't lose too much sleep over it.

[ekoffman]

Ok makes sense. The shape just didn’t add up to me lol. ��*♂️

[Norm B]

The little square one is a filler for the right fuel tank strap when using a donor tank. Didn't use it because I made a cover for the whole assembly. One of the rectangle pieces could be the driver side foot box front filler. The other I can't recall.

Norm

[ekoffman]

Huh, that’s funny. My kits came with a cover that right strap. The rectangle one has two small holes and two bigger ones. That’s why I was wondering what it was for specifically. 177422177423177424

[mladen]

Huh, that’s funny. My kits came with a cover that right strap. The rectangle one has two small holes and two bigger ones. That’s why I was wondering what it was for specifically. 177422177423177424

I wonder if the small one is a cover if you cut off that mounting tab in your second photo. I just assumed I wouldn't get one so I fashioned one out of the scrap I got from cutting a hole for the drop trunk.

[michael everson]

The square one is probably to cover the clutch cable hole on the front of the foot box if going hydraulic. NO idea on the other 2 They all look to be made from stainless? Aluminum patches are usually aluminum.
Mike