Did FFR send the correct carbon fiber bits?

[Shawn818c]

I've yet to begin working on 818c exterior and I've seen some conflicting images making me wonder if I have the correct street front splitter and side skirts.

Here are a few images of what FFR sent.

[lance corsi]

Shawn, splitter is correct, can’t say on the side skirts.
Fwiw, the splitter is wider than the width of your fenders by about 1 1/4” on both sides. Personally I think it looks unfinished but I’m going to run it.

[idf]

The side skirts look the same as those on my 818S. If it helps I could make some measurements.

[Shawn818c]

The side skirts look the same as those on my 818S. If it helps I could make some measurements.

The side skirts did appear to be the correct length up against the side sails.

[Shawn818c]

Shawn, splitter is correct, can’t say on the side skirts.
Fwiw, the splitter is wider than the width of your fenders by about 1 1/4” on both sides. Personally I think it looks unfinished but I’m going to run it.

The front splitter was my biggest concern, I did see someone install one that had 2 "humps" in the circled areas. Maybe that was the race splitter or FFR made a design change.

[lance corsi]

Shawn, my splitter looks identical to the one pictured. It does have a rise in the center but that conforms to the lower grill edge.

[Ajzride]

Looks so much better than the gen 1 splitter.

[Shawn818c]

Thanks everyone for confirming.