ekoffman
12-15-2022, 06:02 PM
Anyone have any pics they can post of their rear wiring in place? I’m about to get the rear aluminum done and I’m thinking I better permanently fix the wiring below the trunk at this point before I can’t drill under there anymore. I’m just not sure where I can fix without getting in the way of anything. Thanks in advance! 🤘
JohnK
12-16-2022, 12:45 PM
Here's a shot of mine. It's secured at the top of the photo with a padded clamp on the underside of the 3/4" tube that's at the step from the upper part of the trunk to the lower part. It's also attached with padded clamps at the corners of the frame nearest each tail light. It's hard to see in the photo, but the leg of the harness that goes to the license plate light is also attached with a push mount cable tie near the end of the diagonal 3/4" tube. The rest is just laying on the tank as neatly as I could get it. Of note, I did re-wrap a good chunk of that harness and shorten the leg going to the fuel pump, as it was way too long for my layout.
https://thefactoryfiveforum.com/attachment.php?attachmentid=134653&d=1599058655