mkassab
11-13-2022, 11:45 AM
I'm going thru the FF Gen 3 Coyote install manual. I have a question regarding the CMCV removal and caping off the vacuum nipple on the CMCV solenoid (refer to the pic below).
1. The instructions state to cap off the solenoid with the removal of the CMCV vacuum line.... which I did as you can see in the picture.
My questions is, can I just delete the solenoid and cap at the intake manifold? I suspect no if the PMC need the wire harness connected to the solenoid???
2. I plan to install a vacuum gauge in the trucks cab, would this vacuum hose connection at the intake manifold be be a good place to install the vacuum sender to or is there a better place to connect the vacuum sender?
Thx, Mark
https://thefactoryfiveforum.com/attachment.php?attachmentid=174852&d=1668354792
1. The instructions state to cap off the solenoid with the removal of the CMCV vacuum line.... which I did as you can see in the picture.
My questions is, can I just delete the solenoid and cap at the intake manifold? I suspect no if the PMC need the wire harness connected to the solenoid???
2. I plan to install a vacuum gauge in the trucks cab, would this vacuum hose connection at the intake manifold be be a good place to install the vacuum sender to or is there a better place to connect the vacuum sender?
Thx, Mark
https://thefactoryfiveforum.com/attachment.php?attachmentid=174852&d=1668354792