Hard top for MK4

[newell]

Is anyone making the fastback hardtop for the MK 4?
Thanks,
Martin

[dbo_texas]

Only place I know of that makes one specifically for FFR MK4 is 427 Hardtops. They are based in the UK. Their top runs about $4K, but very expensive to ship. Several groups on the Factory Five Builder Facebook page have organized group buys to reduce cost. I think all-in the cost to get one was around $5K if I remember. A few folks here on the forum have them. Supposedly top notch kits. Check out JeffP's (https://thefactoryfiveforum.com/showthread.php?42121-JeffP-s-MK4-Roadster-Coyote-TKX-Build-Off-to-Paint-Body&p=491404&viewfull=1#post491404) build here on the forum...he's installing one.
https://www.facebook.com/427HARDTOPS/

[dbo_texas]

Only place I know of that makes one specifically for FFR MK4 is 427 Hardtops. They are based in the UK. Their top runs about $4K, but very expensive to ship. Several groups on the Factory Five Builder Facebook page have organized group buys to reduce cost. I think all-in the cost to get one was around $5K if I remember. A few folks here on the forum have them. Supposedly top notch kits. Check out JeffP's (https://thefactoryfiveforum.com/showthread.php?42121-JeffP-s-MK4-Roadster-Coyote-TKX-Build-Off-to-Paint-Body&p=491404&viewfull=1#post491404) build here on the forum...he's installing one.
https://www.facebook.com/427HARDTOPS/

Be aware this doesn't work w/ FFR roll bars. You need to get the Breeze roll bars and trim them down even shorter to make it fit under the top.

[KDubU]

You can also reach out to Mr Bruce who does do tops but it can take a while. I would go with the 427 Hardtops one, modify your rollbars and then get it fitted and painted.