View Full Version : wiring breeze automotive quick disconnect for headlights
toadster
10-09-2022, 08:49 PM
it seems that the best way to do this is to run the wires through the headlight bucket and then to the quick disconnect - correct?
the quick disconnect ends are much too big to fit through the headlight bucket grommet
am I assuming correctly?
pic to show sizing, obviously not yet cut/attached :)
173589
michael everson
10-10-2022, 03:37 AM
I think you are supposed to cut the green-yellow-brown wires in half. Solder one end to the end of the head light harness and the other end to the headlight wires coming out of the harness.
Mike
toadster
10-10-2022, 04:28 PM
I think you are supposed to cut the green-yellow-brown wires in half. Solder one end to the end of the head light harness and the other end to the headlight wires coming out of the harness.
Mike
yes, I've done the rears already - but no headlight bucket back there... I think I'm good to cut in half then splice into the Headlight wiring after the bucket
seems common sense but figured I'd ask before I trap two end of the harness between that small grommet :)
Thanks!