Honest Ernie
10-04-2022, 03:19 PM
Hello Everyone. Honest Ernie here with his cobra build #10314
Just a quick question to make sure I am doing this right and not cutting off something I will need latter ha ha. I am doing what I can while I wait for my POL to show up.
2015 IRS spindle
So I am reaming out the countersunk hole out to 5/8.
Cutting off the ear as shown in the attached photo.
Is this correct. Thank you in advance on the newbie question.
Honest Ernie
Just a quick question to make sure I am doing this right and not cutting off something I will need latter ha ha. I am doing what I can while I wait for my POL to show up.
2015 IRS spindle
So I am reaming out the countersunk hole out to 5/8.
Cutting off the ear as shown in the attached photo.
Is this correct. Thank you in advance on the newbie question.
Honest Ernie