Fbird
08-09-2022, 10:58 AM
170814170815
Hi all, just wanted to run this by everyone because I don’t want to accidentally destroy my transmission due to my own lack of knowledge. I read several past posts about people having trouble getting their driveshafts in place due to them being too long. Mine just went in once the magic angle and approach was worked out. Otherwise it did seem to be impossible at first. It is a tkx tranny behind a coyote to a solid axle rear end.
The photos show how much clearance there is with suspension hanging and with weight on the wheels. There has been no alignment done so that could change the clearance with the angle of the axle some if I am understanding how the 3 link works.
Is this an ok fit?
Thanks all.
Hi all, just wanted to run this by everyone because I don’t want to accidentally destroy my transmission due to my own lack of knowledge. I read several past posts about people having trouble getting their driveshafts in place due to them being too long. Mine just went in once the magic angle and approach was worked out. Otherwise it did seem to be impossible at first. It is a tkx tranny behind a coyote to a solid axle rear end.
The photos show how much clearance there is with suspension hanging and with weight on the wheels. There has been no alignment done so that could change the clearance with the angle of the axle some if I am understanding how the 3 link works.
Is this an ok fit?
Thanks all.