Cobra Steering Wheel Insert

[Abomination]

I'm having the hardest time finding a cobra emblem insert to replace the factory five one for the steering wheel factory five supplies. Anyone know where to buy one (the red/white/blue one preferably).

Thanks in advance

[frankb]

Tony D Branda has them: www.cobranda.com

[seagull81]

https://www.**********accessories.com/p-31-cobra-cap-red-white-blue.aspx

[Bob Cowan]

I used a nose emblem. Cut off the posts, and trim the outside edge just a smidgen.

https://i.imgur.com/3TlNLdb.jpg

[vtullomk4]

Actually I been meaning to post my solution. I found a guy on Etsy in Canada that makes 3D printed badges. Gave him dimensions of the FF badge and he made the attached. Matches my hood and trunk badges. Should be around $100. Highly recommended. What I like about it, it fits in the FF bezel, covering the screws for a finished look.

Vince

168784

https://www.etsy.com/listing/696819090/

[vtullomk4]

Here is the picture of the badge inserted in the bezel. I’ll post a picture in the wheel when I get a chance.

Vince

168785

[Alan_C]

Finish Line used to sell a badge that was perfect for this application. The badge I used did not require the removal of any mounting pins. I know they are not a recommended source with all the bad reviews lately. Looking at the badge I used, I see it is different from the one you are looking for.

168786

[john42]

Actually I been meaning to post my solution. I found a guy on Etsy in Canada that makes 3D printed badges. Gave him dimensions of the FF badge and he made the attached. Matches my hood and trunk badges. Should be around $100. Highly recommended. What I like about it, it fits in the FF bezel, covering the screws for a finished look.

Vince

168784

https://www.etsy.com/listing/696819090/


I just ordered mine! Looks great! Can’t wait to install it!

[vtullomk4]

Just FYI. I had him make the emblem a bit oversized. I wanted to be able to sand down the edge for a perfect fit. You will need to do the same.

Vince

[red.barchetta]

Found this.


https://www.summitracing.com/parts/sdk-s1ms-3649-c

[john42]

Found this.


https://www.summitracing.com/parts/sdk-s1ms-3649-c

That one is too small (1.81 inches) The factory five bezel is 2.375. Also, the review on that state it is thin aluminum.

[CaptB]

Just ordered from etsy. There are 4 available and 2 others had them in their cart. Might be only one left pretty soon.

[john42]

Just ordered from etsy. There are 4 available and 2 others had them in their cart. Might be only one left pretty soon.

When I contacted him there were 0. He was happy to open it up and produce more.