Russ Thompson turn signal sticking

[Alex_V]

I can't seem to find the contact info for Russ. Ordered the turn signal kit long ago, and cant even locate original emails. I am sure its something on my end, as the kit is top quality.

When I tighten the hex bolt that holds the steering wheel my turn signal assembly gets stuck and is no longer free moving. When I turn the steering wheel it actually moves the turn signal lever.

Anyone had a similar issue, and ideas on how to tweak things?

[CaptB]

Yes. I'm eagerly waiting on what you place here after talking with him.

rtcobra@comcast.net

I don't have a phone number in my e-mails from him.

Capt. B

[David Williamson]

The back of the steering wheel hub is rubing on the turn signal, you need to pull the steering wheel shaft out a little to give it clearance.
David W

[AROCK]

Russ Thompson, 510-374-7376

[Alex_V]

The back of the steering wheel hub is rubing on the turn signal, you need to pull the steering wheel shaft out a little to give it clearance.
David W

That is most likely the case. Will give this a go before reaching out to Russ.


Thanks for all your comments.

[glastron351]

The back of the steering wheel hub is rubing on the turn signal, you need to pull the steering wheel shaft out a little to give it clearance.
David W

Yes I had the same issue, moving the steering wheel shaft very minutely forward corrected the issue for me....good luck

[Ducky2009]

The steering shaft length is adjustable. Loosen the set screws in the upper bearing block and pull the upper shaft out a little.