Motor Mount Misalignment–Steering Shaft Interference

[4.6 litre]

Guys

I was performing a coyote engine fitment without the bell house and tranny. I was simply vertically lowering the engine onto the chassis. Both my driver and passenger side motor mounts were not flush with the chassis. Also my steering shaft interfered with the coyote engine. I have attached several pictures of the problem. Can you give me any advice on how I could correct this problem?

165346

165347

165345

Thanks for your response,

Damien

[michael everson]

You need the FFR supplied spacers that go inside the motor mounts. If you ordered the coyote fitment package you should have gotten them. There are 6 pieces total. About 1/2 inch thick steel.

https://www.factoryfive.com/wp-content/uploads/2018/07/Coyote-2011-14-Fitment-roadster-rev-X.pdf
See page 31
Mike

[Jeff Kleiner]

Mike beat me to it. With a Coyote you have to use the 4.6 mounts AND the mount spacers.

Jeff

[4.6 litre]

Guys,

Thanks for the information.

Damien