Mounting LED headlight bulb drivers

[JohnK]

I'm trying to figure out how I want to mount the LED headlight drivers to the back of the plastic headlight buckets. I have the kit from Watsons Streetworks (similar to what Breeze sells) and the drivers look like the photo below. There are what appear to be holes for fasteners but hardly any room for the head of a fastener. Has anyone figured out what fastener will fit in these? I could take one down to the hardware store and rummage through their bins, or I could grind off half the head off of a normal screw to get it to fit in there, but if someone has already solved this riddle I'd appreciate a hint.

https://thefactoryfiveforum.com/attachment.php?attachmentid=165260&d=1649600983

[John4337]

Here's my Breeze driver mounted on the back of the bucket. Large Zip Tie, holes sealed with silicone. Some 3M mounting tape on each end.

Hope this helps.

John

https://thefactoryfiveforum.com/attachment.php?attachmentid=165265&d=1649603573

[boat737]

Here's the Watson's Streetworks LED headlights I did.

I made two small plates out of about 1/8" aluminum plate, one on the inside of the bucket, and one on the outside. They bolt together and hold the little transformer on the backside.

[JohnK]

Here's the Watson's Streetworks LED headlights I did.

Nice work. I'm hoping to come up with something similar, but yours is the older version of the LED driver that had larger bosses with screw holes. The newer ones only have the tiny holes through the tabs on the sides.

Zip ties and some 3M VHB tape may ultimately be the way to go.