Part # for Roadster Flexible Front Brake Line to Caliper?

[GWL]

I need a part number for the roadsters flexible front brake hoses. One end attaches to the hard line, the other end attaches to the caliper via a banjo fitting.

https://live.staticflickr.com/65535/51941918282_94e88bd9e8.jpg (https://flic.kr/p/2n8VUFd)Screenshot (303) (https://flic.kr/p/2n8VUFd) by George Ligon (https://www.flickr.com/photos/161275344@N04/), on Flickr

Has anyone else had interference between that banjo fitting and the lower A frame suspension? At full drop it interferes with the rear A frame, not sure if it does when there is weight on the suspension. There is not much ability to move that banjo fitting around out of the way of the lower A frame.

Thanks, George

[JeffP]

The part number is 14945 20" Stainless Braided 35* Banjo Brake Line

[GWL]

The part number is 14945 20" Stainless Braided 35* Banjo Brake Line

Jeff,
Thanks but I need more.

Where is that part # from?

FFR ?, I've got a call into them but no call back yet.

Your description, 20" Stainless, braded with 35º banjo fitting is right on but my search does not find it.

Thanks again, George

[Jeff Kleiner]

Here ya’ go George:

https://www.maximummotorsports.com/MM-Stainless-Brake-Hose-Kit-1994-04-Mustang-front-P686.aspx

Jeff

[GWL]

Here ya’ go George:

https://www.maximummotorsports.com/MM-Stainless-Brake-Hose-Kit-1994-04-Mustang-front-P686.aspx

Jeff

Thanks Jeff. I'd been looking at those but they looked shorter than 20". But it says on their site that it may not be the correct picture.

I don't have any interference when the car is on the floor/ground but when it's up on jack stands I must have turned the wheel all the way once and it slightly damaged the banjo/hose end of the fitting.

Thanks again, George

George