Seeking advice on how to mount fuse to 4" round frame tube

[kmseddon]

Hello Experts -

The shop that I bought my MKIV kit convinced me to use an American Autowire wiring harness kit instead of the Ron Francis one because it doesn't have extra wires, etc. I am thinking of mounting the main fuse block which is about 3" x 3" on the 4" tubing frame near the passenger's side engine mount because I have a Breeze batter mount that puts the battery near the x-frame. Want to mount near the battery to minimize the length of unfused lines coming from the battery. The issue is the fuse box is flat. Any suggestions on creative ways to mount a flat surface onto the 4" frame? Does anyone sell a flat surface that can be riveted onto the 4" tube? Here is a picture of what I am looking to mount. Thank you in advance for your help!

163486

[egchewy79]

find someone to 3D print you a mount. you bought your MK4 from a shop? Why didn't you just purchase from FFR (aside from the 9mo waitlist)?

[steno]

How about a location on the passenger foot box that’s accessible.

[narly1]

https://stauff.com/en

[toadster]

a couple of metal zip ties ?

[boat737]

You could mount it just a few inches away from the battery on the 'F' panel. Or if you are set on the 4" frame tube, fabricate a bracket that has a radius on one side to fit on the frame tube, and a flat side on the other for the fuse mount.

[phileas_fogg]

Call http://lsbilletworks.com and see if they can make you something. They already make clamps that are radiused to fit the 4" tubes.


John

[BrewCityCobra]

Not the exact same hardware but the concept is the same. I ended up mounting my primary circuit breaker to the frame near the F-panel using a panel I fabricated. Kept things close to the battery but was easily accessible and very secure. I also didn't want bolts passing through the F-Panel itself. The plate is relatively thick - but I can confirm what it is exactly later if you are interested.

Just an option.


163545

[Just puttering]

Consider if or when one of the fuses needs replaced, trying to reach it on the 4” tube on a completed car.! What may be in the way for you to get a wrench in there to access it.

[Hoooper]

Yeah, I would try to mount it higher than that. With the the car on the ground it could be pretty tough to reach without laying on your nice paint job

[smithtlw]

I 2nd the printed part route. Just not sure what types of temperatures you expect in that location? Printed PETG parts are good to around 180F. Something that could utilize a couple of large hose clamps:
163649163650163651163652

[Windsor]

3D-printed is an excellent way to go if you are set up or know a hookup. If you were near me (let's say McKinney/Plano TX area), I'd give you a hand.

I wouldn't trust PETG under the hood, though. Also, PETG is a pain to print.

I'd recommend ASA or ABS.

[Nigel Allen]

Weld or bolt a fabricated bracket onto the Breeze battery carrier. Attach the fuse assembly to the bracket. Then the fuse will be right next to the source of supply. Simple...:)

[j.miller]

Put it where you can't see it but still easy to access. A couple feet of battery cable isn't going to be a problem...da Bat

[kmseddon]

Thanks Narly1 - I am having a little trouble digesting their Parts catalogue. Have you used some of their parts before? What part were you thinking would work?