Drive shaft adapter for IRS

[Slider]

I went to install my drive shaft today and am unable to locate the drive shaft adapter. I’m also unable to find it listed on my inventory list. Does anyone know the part number so I can try and see if I ever received it? I’d also appreciate a photo of it in the event anyone has one handy? And since I’m asking, does anyone know if there are after market versions available in the event that FF does not have them in stock?

[jamminj]

I don't know the part number but there are 2 of them
but for your info
one is for the center section from an automatic car
and one for center section from a stick shift car

[Indy Shu]

Are you going IRS? Mine showed as part #15946 and was included in box 10 with the IRS parts. It was labeled automatic driveshaft adapter. If you have to order you should measure inside the snout to confirm the diameter.

[Slider]

Yes, IRS.. And thank you for the part #. I'll check my shipping logs again... I went through all my remaining parts today without any luck.... and it doesn't look like they are currently in stock if I have to reorder. Fingers crossed

[Jim1855]

I have one I'm not using. Fits into the manual diff flange but the bolt pattern seemed a bit off. Too the best of my knowledge it was supposed to be for a manual unit.

Not sure what the differences are between the auto and manual pieces.

Jim

[Slider]

I have one I'm not using. Fits into the manual diff flange but the bolt pattern seemed a bit off. Too the best of my knowledge it was supposed to be for a manual unit.

Not sure what the differences are between the auto and manual pieces.

Jim

Jim, I'll message you directly.