Hazard Switch Wiring

[John J Phillips]

Confession - I am hopelessly lost in the wiring. Any help would be appreciated. I am trying to wire the hazard switch. I am using the RF wiring and I have a 6 pin switch from FFR that shows, on and on. The RF diagram show only the left and right front wiring going to the switch and the pink hazard flasher wire. How is this six pin switch wired and what about the left and right rear wires? Shouldn't it be a on / off switch?
As always, thanks
john

[Papa]

Connect the two pink wires to the center pins on the switch, and then the left/right to the two pins on one end of the switch (doesn't matter which).

[Jeff Kleiner]

Factory Five has always supplied a DPDT toggle for hazards although all that is required is a DPST (I think this may be because they can only get it in a DPDT to match the other toggles). It is an ON/OFF/ON but gets wired so that in reality it's an ON/OFF/OFF. Clear as mud, right? Anyway land the pink flasher feed wire to BOTH center terminals. Land the dark green LF turn signal wire to one of the end terminals and the light blue RF turn signal wire to the other terminal on the same end. The other two end terminals are unused. The LF and LR as well as the RF and RR turn signal wires are joined together at the turn signal switch.

Hope that helps!

Jeff

[John J Phillips]

Thanks for your help. I will proceed.