Bluemont
12-28-2021, 02:54 PM
Last night I went to work installing the spindles on my Coupe-R kit. The instructions say to install a spacer on the bottom ball joint below the castle nut so that the nut sits high enough to engage with the cotter pin. It says nothing about spacers for the top. When I installed the bottom nut with the spacer, it came out just about right. However, when I install the castle nut on the top, it looks like it doesn't end up far enough down the top ball joint to engage the cotter pin as much as I would like. Has anyone else run into this? I'm thinking I could either make a spacer for the top or even just use a couple of washers to get the nut to the correct spot. But before I do I wanted to see if anyone else had run into this or if I was missing something?