View Full Version : Rear harness routing to hood?
richtersand
10-15-2021, 12:48 AM
Hi all, I am curious how people route the branch of the rear harness that goes to the trunk up through the trunk floor. I would love to route it though the passenger hoop stub but it looks like it'll be impossible to get a drill bit through there. Pic of the branch in question below. Thanks in advance!
https://thefactoryfiveforum.com/attachment.php?attachmentid=154513&d=1634276444
michael everson
10-15-2021, 03:45 AM
I go through the trunk floor just ahead of the angled roll bar mount.
Mike
Jeff Kleiner
10-15-2021, 04:41 AM
Same as Mike.
Jeff
steno
10-15-2021, 08:01 AM
Ditto!
rich grsc
10-15-2021, 08:08 AM
YEP^ how simple it is
CaptB
10-15-2021, 08:10 AM
Like your flooring, I'm about to install some polyurea flooring myself.
RBachman
10-15-2021, 08:52 AM
Like your flooring, I'm about to install some polyurea flooring myself. Dittos on that flooring. My only gripe is that the specs in the floor make it hard to find what you just dropped. LOL. But it is TOUGH and takes a good bit of punishment. Just make sure the prep is done properly.
egchewy79
10-15-2021, 09:50 AM
I did mine through the side wall panel just behind the shock tower.
This is what did.
https://thefactoryfiveforum.com/attachment.php?attachmentid=84680&d=1524443144
https://thefactoryfiveforum.com/attachment.php?attachmentid=93968&d=1537567921
CaptB
10-15-2021, 10:02 AM
Dittos on that flooring. My only gripe is that the specs in the floor make it hard to find what you just dropped. LOL. But it is TOUGH and takes a good bit of punishment. Just make sure the prep is done properly.
The process includes a complete diamond grind of the floor, all pits/cracks are fixed, basecoat (polyurea), chip and clear (polyespartic), 4 times stronger than epoxy and lasts longer.
Blitzboy54
10-16-2021, 05:56 PM
I was very similar to Papa. I fed it out the side by the back roll bar mount. Used a grommet to seal it up on the outside.
154542
nucjd19
10-16-2021, 06:33 PM
I followed Papa's lead and went with the side aluminum on the passenger side of the trunk.
richtersand
10-17-2021, 12:34 AM
I was very similar to Papa. I fed it out the side by the back room bar mount. Used a grommet to seal it up on the outside.
154542
Thanks Blitz. Curious, why the tape on certain areas of the aluminum? What’s the benefit of that? Thanks in advance.
Blitzboy54
10-17-2021, 04:38 PM
Thanks Blitz. Curious, why the tape on certain areas of the aluminum? What’s the benefit of that? Thanks in advance.
That’s a common aluminum tape. I ran it along all my seams. Probably overkill but between the silicon and that I’m pretty confident I won’t get any water in there from underneath