LS install problem

[frankc5r]

I am using LS3 crate motor with surpentine belt . The motor comes stock with power steering pump and pulley which I can't use as the ps pulley hits the chassis.
What have users done in this situation? Possibly put in idler and run shorter belt?- and if so what did you use?
Any help appreciated.
Frank

[Kamp]

I am using LS3 crate motor with surpentine belt . The motor comes stock with power steering pump and pulley which I can't use as the ps pulley hits the chassis.
What have users done in this situation? Possibly put in idler and run shorter belt?- and if so what did you use?
Any help appreciated.
Frank

Holley EFI site has several mounting systems available shown in the LS Swap section. Take a look.

[edwardb]

Truck build here. Some front end as your 33 Hot Rod and also with an LS3. After a lot of research, I ended up putting a Vintage Aire 175011 front runner setup on mine. There are lots of options. And this one was not the cheapest. But very high quality and fits perfectly. FWIW

[frankc5r]

Holley EFI site has several mounting systems available shown in the LS Swap section. Take a look.

Thanks to both replies

[FFinisher]

I used CVF racing,Pricey, but not as expensive as the Holley stuff for my LS 6.0

[frankc5r]

I used CVF racing,Pricey, but not as expensive as the Holley stuff for my LS 6.0

Which one did you use. I looked at web site and tons of choices. Thanks