Coyote fly wheel

[cfriedman67]

The instructions say use a 19 mm socket to remove the flywheel. From the picture of my coyote what am I missing? I don’t see a 19 mm bolt. 147516

[michael everson]

Is that a GEN 3? Never seen that before. I assume you remove the bolts that are recessed in the flywheel.
mike

[cfriedman67]

Yes it is a gen 3. Not even sure what type of bolt head I need to remove them.

[cfriedman67]

147517147517

A better picture

[rich grsc]

Torx bit looks like me
just go grab one at Lowe's

[cfriedman67]

Thanks. I’ll ask mike forte what size since I bought the engine from him.

[Bob Cowan]

That looks like a Torx bolt. But I've never encountered one that big. https://www.mcmaster.com/torx-bits/for-drive-style~torx/

[edwardb]

Yup they're Torx. Not a perfect fit, but T55 will get them out. What I had on hand. You won't use them again. Looks like Factory Five's cut and paste from previous Gen Coyote's needs to be corrected.

[cfriedman67]

It’s a T55 in case some one needs to know.

[Hoooper]

If T55 is not a perfect fit its probably torx plus, which is what it looks like to me anyhow

[edwardb]

If T55 is not a perfect fit its probably torx plus, which is what it looks like to me anyhow

Exactly what it is. Not quite as easy to find and since all you need to do is get them off and not reuse, a regular T55 gets the job done.