austingoblue
05-07-2021, 08:28 PM
Hi everyone. So, I just received my KRC power steering pump kit from f5 and went to install it on my Gen 2 Coyote.
First, I installed the bracket. How can anyone install it wrong? I took the 3 90mm bolts with washers and the spacers and installed it per the instructions. The larger spacer goes on the bottom inside and the two smaller spaces go on the top and the outside. easy. Then I installed the KRC pump to the bracket and this is where I am finding trouble. When I snug the pump up to the bracket, I cannot rotate the pump close to the pulley in order to get the belt on, because the pump is interfering with a dimple on the engine (see pics) I cannot rotate the pump like the instructions say at all because of that dimple on the engine. I asked Paul, and he sent me a picture of hi (the last picture), and his is no where near the dimple...so he could rotate his freely. WHy would mine be so deep??? I am at a loss. [/ATTACH]147492147493147494147496147498
Anyone have any idea what I am doing wrong?
First, I installed the bracket. How can anyone install it wrong? I took the 3 90mm bolts with washers and the spacers and installed it per the instructions. The larger spacer goes on the bottom inside and the two smaller spaces go on the top and the outside. easy. Then I installed the KRC pump to the bracket and this is where I am finding trouble. When I snug the pump up to the bracket, I cannot rotate the pump close to the pulley in order to get the belt on, because the pump is interfering with a dimple on the engine (see pics) I cannot rotate the pump like the instructions say at all because of that dimple on the engine. I asked Paul, and he sent me a picture of hi (the last picture), and his is no where near the dimple...so he could rotate his freely. WHy would mine be so deep??? I am at a loss. [/ATTACH]147492147493147494147496147498
Anyone have any idea what I am doing wrong?