WTB - Gen 2 Coyote Components for my Roadster

[juddster]

Hi all,

Putting the Gen 2 Coyote into my Roadster but since this was a partial build and the previous owner was going to use a big block I am in need of some parts. Hoping to get them from someone on the forum.

Here is what I'm looking for:
Accelerator Pedal Plate
Motor Mounts
Misc brass fittings
Intake tube (I have the Mass Air Meter)
Oil Pressure sender

Thanks!!

[nuhale]

Hi all,

Putting the Gen 2 Coyote into my Roadster but since this was a partial build and the previous owner was going to use a big block I am in need of some parts. Hoping to get them from someone on the forum.

Here is what I'm looking for:
Accelerator Pedal Plate
Motor Mounts
Misc brass fittings
Intake tube (I have the Mass Air Meter)
Oil Pressure sender

Thanks!!

Accelerator Pedal Plate: Assuming this is the mount? FFR can get you this part.
Motor Mounts: Energy suspention 4.1127G on amazon or ebay for around $150.. You will need the motor mount spacers from FFR.
Misc brass fittings: If these are the A/N fittings I can help with these as I bought extra. I used aluminum parts, not brass.
Intake tube (I have the Mass Air Meter): Your lucky day... I have a spectre setup that I am swapping out. I will sell it for $50 +s/h
Oil Pressure sender: You can get this part and the adapters on speedhut.com . It is a 100psi 240-33ohms which you can find on amazon for a little cheaper.

Make sure you have the right aluminum setup in the DS footbox. FFR can sell you the correct pans if not setup for this.

IM me with questions or if interested in the CAI.