Forte's Hydraulic Clutch Kit

[BrewCityCobra]

I was wondering if anybody happens to have a photo or two showing how they ran their hydraulic lines for the Forte's Hydraulic Clutch Kit. I'm in the process of running my brake lines and wanted to make sure I wasn't stepping on any toes going forward since I don' have the kit/engine in hand yet to see exactly where those items will end up.

Thanks!

-Brew

[RoadRacer]

I don't have a great picture (and I didn't use Forte's external slave kit, I used his internal throwout bearing. But the gist is the same.

I went down outside of the existing brake lines, then across bottom of firewall with some hard-line, where it connected to a flexible stainless line.

If you zoom in to bottom of firewall you can see the connection.

146225

[Fman]

You should be fine running brake lines how you want, the braided line that comes with Mikes kit can easily be routed anywhere you want.

Here are a couple pics, I ran mine down on the lower pedal box frame out the side of foot box.
https://thefactoryfiveforum.com/attachment.php?attachmentid=136086&d=1602212079
https://thefactoryfiveforum.com/attachment.php?attachmentid=136087&d=1602212093

[BrewCityCobra]

You should be fine running brake lines how you want, the braided line that comes with Mikes kit can easily be routed anywhere you want.

Here are a couple pics, I ran mine down on the lower pedal box frame out the side of foot box.
https://thefactoryfiveforum.com/attachment.php?attachmentid=136086&d=1602212079
https://thefactoryfiveforum.com/attachment.php?attachmentid=136087&d=1602212093

Excellent, I was hoping it would be a stainless flex line for ease of assembly. Looks like this shouldn't be too much of an issue.

Thanks for the pics!

[nucjd19]

You should be fine running brake lines how you want, the braided line that comes with Mikes kit can easily be routed anywhere you want.

Here are a couple pics, I ran mine down on the lower pedal box frame out the side of foot box.
https://thefactoryfiveforum.com/attachment.php?attachmentid=136086&d=1602212079
https://thefactoryfiveforum.com/attachment.php?attachmentid=136087&d=1602212093

I don't have the Forte clutch kit but running hydraulic TO bearing as well. Ran it just like Fman.

[SJDave]

Here's some more pics for you, Mark 3.1, TKO 600, 347 SBF. I know this CNC brand Slave is no longer available, and the adaptor to a stock clutch arm I fabricated and gave the design to Mike Forte, no way I was pulling the engine out again to replace the clutch arm!

[RoadRacer]

oh jeez, roadster forum, so sorry :D

[FLPBFoot]

Similar to SJDave I ran mine out of the back of the driver foot box. I ran my rear electrical harness out a hole in that same area so ran the SS flex line through the same grommet. Just the right length to get to the slave cylinder.

Steve