Alt / starter harness firewall hole location?

[richtersand]

Hi all, I have been studying a lot of build threads and do not commonly see the suggested FFR location used for the alt/starter branch of the chassis harness. But I can't tell where/how people are routing this branch. Suggestions?? Pics would be very helpful. Thanks in advance!

Here's the suggested location:

https://thefactoryfiveforum.com/attachment.php?attachmentid=143744&d=1614892059

[JohnMac]

Go into FF5 site and look for instructions for all the different models- you’ll find most of the instructions for just about everything. Ron Francis also has the instructions for their FF5 kit. I recently found an early version dated 2012 which was a little different. The holes in your photo are to the right of the center support bracket. But you should see a page showing where you place the holes to run different wire bundles. I’m sure everyone does it a bit different. For example when we started to mount the vintage air ac compressor, we couldn’t get the drive belt to line up with our setup. We ended up using a different mounting system.
Mac morgan

[richtersand]

Go into FF5 site and look for instructions for all the different models- you’ll find most of the instructions for just about everything. Ron Francis also has the instructions for their FF5 kit. I recently found an early version dated 2012 which was a little different. The holes in your photo are to the right of the center support bracket. But you should see a page showing where you place the holes to run different wire bundles. I’m sure everyone does it a bit different. For example when we started to mount the vintage air ac compressor, we couldn’t get the drive belt to line up with our setup. We ended up using a different mounting system.
Mac morgan

Thanks Mac, appreciate the perspective.