kmseddon
03-02-2021, 11:13 AM
Hello everyone -
First off, I hope you all are safe and healthy. Second, my son and I really appreciate all the support and effort you guys put into this forum (special shout out to Paul). It certainly has helped us with our first build.
That said, we are confused about how to use the FFR hardware to connect up cabling to the accelerator pedal. We clipped off the larger end of the wire. But the photos in the assembly manual has too many fingers in the way to see where the white square plastic piece goes, how the ball at the end of the wire interacts with it, how the wire passes through the ball clamp, how the ball clamp attaches to the pedal, and how the set screw holds the wire.
Anybody got a good photo of how those pieces interact with each other sans fingers?
We will be connecting to a small block, not Coyote.
Thanks so much.
P.S. And then at the risk of asking, are we really going to end up regretting not going with the mechanical assembly from Fortes in the end?
First off, I hope you all are safe and healthy. Second, my son and I really appreciate all the support and effort you guys put into this forum (special shout out to Paul). It certainly has helped us with our first build.
That said, we are confused about how to use the FFR hardware to connect up cabling to the accelerator pedal. We clipped off the larger end of the wire. But the photos in the assembly manual has too many fingers in the way to see where the white square plastic piece goes, how the ball at the end of the wire interacts with it, how the wire passes through the ball clamp, how the ball clamp attaches to the pedal, and how the set screw holds the wire.
Anybody got a good photo of how those pieces interact with each other sans fingers?
We will be connecting to a small block, not Coyote.
Thanks so much.
P.S. And then at the risk of asking, are we really going to end up regretting not going with the mechanical assembly from Fortes in the end?