FFR Premium Top by Rod Top Measurement Needed

[GWL]

I can not find the template for the location of the hole just behind the door. This is the FFR Top by Rod Tops.

So, can someone give me some measurement to locate it without the template?

Thanks, George

[65 Cobra Dude]

George, you can get the instructions on line and print out the template.

http://rodtops.com/pdf/RodTops-FFR-Owners-Manual.pdf

Henry

[GWL]

George, you can get the instructions on line and print out the template.

http://rodtops.com/pdf/RodTops-FFR-Owners-Manual.pdf

Henry

Henry,

Thanks for the response. I think I've seen those instructions somewhere in my past but could not located them. Thanks!

However, in those instructions it says not to use those patterns that are in the instructions as they are not to scale. They say to use the patterns that come with the kit.

What I can see from those instruction patterns is that the holes are 52" apart.

How far back from the door jam edge is that 1/2" hole?

Then how far in from the inner body line edge is the hole?

Anyone, thanks, George

[Papa]

Mine measures 1-1/4" from the door jam edge to the center of the hole.

[Papa]

Here is the 1:1 template from my manual. Be sure to select "Actual Size" in your printer settings when you print the file.

[GWL]

Here is the 1:1 template from my manual. Be sure to select "Actual Size" in your printer settings when you print the file.

Thank you Papa.

I'll use the template and the measurements to double check.

George

[GWL]

Mine measures 1-1/4" from the door jam edge to the center of the hole.

I printed the templates and then measured the 1-1/4" distance. It was right on the mark. :D

Thanks again, George