Herb's door panels

[kobra01]

I'm attaching my door panels but there have been some post's that the door panels may not stay in place. Does the adhesive side not stick to the door real well or does the velcro come apart.
I really don't want to use screws to hold them on, so maybe a little bit of silicone?

Thanks,

Ken

[Boydster]

Herb uses some very good velcro. Just make sure the door skin is clean and dry. Mine have been on for o er a year with no issues... Not 1.

[Hacksaw84]

I'm attaching my door panels but there have been some post's that the door panels may not stay in place. Does the adhesive side not stick to the door real well or does the velcro come apart.
I really don't want to use screws to hold them on, so maybe a little bit of silicone?

Thanks,

Ken

You can pull the pocket flap down and run a screw into the body on either side. It will be pretty well hidden behind the pocket. This in addition to some Velcro to just lock it down.

[NiceGuyEddie]

The velcro Herb gave me 15 years ago is still holding fine!

[TMartinLVNV]

I'm attaching my door panels but there have been some post's that the door panels may not stay in place. Does the adhesive side not stick to the door real well or does the velcro come apart.
I really don't want to use screws to hold them on, so maybe a little bit of silicone?

Thanks,

Ken

For me, the velcro did not stick well at all. After one night, they fell off. This was on new paint and when it was warm. I used silicon and it has held them in place perfectly.

[JohnK]

It seems to me that the obvious answer here would be some door panel clips like what's used on OEM door cards. Has anyone tried using those?

[rich grsc]

I used the black trim screws with the integral washer. You don't even see them once installed.

[scottiec]

also used black trim screws.

[kobra01]

Ok thanks for the ideas guys.