Ignore. I am an idiot. Gen 2 3-Link DS Shock Clearance to Panhard Mount

[shmelty]

We ran into an issue today on the '33. I am about 1/4-5/16" of inch off center with my 3-Link rear end. As you can see in the attached images, I only have about 1/8" clearance between spring and panhard mount. I don't have any more room to move over to the PS. I have the car on the ground now and the ride height at the frame (right in front of the rear tire is about 11 inches). Any suggestions to get some more room to move over? Then I could lower the height with spring adjustment.

Thanks,


Sean

134479134480134481134482

[CDXXVII]

Just throwing this out there. Have you set your pinion angle yet? This may help a bit with clearance.

[shmelty]

I am an idiot. Ride height was set too high and would not all for sag. Basically stuck at full droop. Lowered ride height and it worked perfectly. Plenty of room and it is centered now!