Ram clutch on the Coyote flywheel

[Fuel an]

Hi All,

I have a TKO600 package from Forte with the Ram clutch (cable) and Tremec Factory style bell housing. I was trying to put the Ram pressure plate on the stock flywheel today and the dowel pins on the flywheel are too big. I really don’t want to take the flywheel off and get the smaller pins pressed in, has anyone drilled the alignment holes on the pressure plate out to fit the Factory dowel pins? This seems like the simplest solution.

[GTBradley]

I have the same setup from Forte’s and I believe I remember drilling out the holes on the pressure plate. It should be in the instructions, but if not don’t hesitate verify with Mike. He loves to be helpful.

[Fuel an]

I have the same setup from Forte’s and I believe I remember drilling out the holes on the pressure plate. It should be in the instructions, but if not don’t hesitate verify with Mike. He loves to be helpful.

Thank you GTBradley, for some reason I didn’t see any instructions in the boxes, I will dig through them again and make sure I didn’t miss anything.

Have you liked the clutch, pedal pressure and activation? This is my first Ram clutch.