Equal length exhaust hangs low

[Hojo]

I’m waiting for my appointment with State Police Salvage for my VIN #. One concern left to fix. My equal length exhaust manifold protrudes 1 3/8” below the lowest other point on the car. It scrapes the asphalt occasionally where the 2 pieces join. There is plenty of room above the low point of the manifold for it to be out of the way. Maybe this clearance isn’t an issue in a WRX so all aftermarket manifolds will be this way or maybe mine is the only problem. Can I buy a different manifold and cure this instantly? If so, please recomend a brand and model.

[redbudrr]

There are several posts about this under engine and transmission. Sounds like Perrin does not hang below chassis.

[Hojo]

Anybody buy an equal length manifold that does not hang below the chassis? The Perrin ones start at $ 1,2000.00

[Ajzride]

I don’t recall mine hanging low before I pulled it off. It’s sitting in storage, I can go pull measurements sometime this week.

[longislandwrx]

I have the small tube Perrin. it doesn't appear to hang very far down... i can measure off the block if you'd like.

you can get them around $900 when they are on sale. I picked up a set for $300 used (just needed a little aluminum foil treatment)

[Sgt.Gator]

My Perrin works fine.

[twgab]

AFE works good as well.