Grkmf3
06-25-2020, 11:11 AM
Morning Gents,
Figured I'd share a piece I made.
The stock clutch pedal was a bit too far for me to push without sliding forward a couple inches or moving the seat forward so instead of chopping up and welding the arm itself I made a block on a 3D printer for temporary until I had a chance to machine out a piece out of aluminium. This fixed the issue perfectly
130505130506130507
Figured I'd share a piece I made.
The stock clutch pedal was a bit too far for me to push without sliding forward a couple inches or moving the seat forward so instead of chopping up and welding the arm itself I made a block on a 3D printer for temporary until I had a chance to machine out a piece out of aluminium. This fixed the issue perfectly
130505130506130507