Gen 2 Coyote CAN HS (+), CAN HS (-), and 12V Key on wires...

[flip1216]

Going through the bowl of spaghetti scattered across my engine bay right now and came across these three wires (CAN HS (+), CAN HS (-) and 12V Key On). Can someone assist me with what these are? Should I remove them from the harness? Do they have a potential (future) use, if so - should I just re-route them to behind the dash (they currently run on the leg to the PCM from the fuse box)?

The Ford Coyote manual says they "Provide access to High Speed CAN Bus if needed"; the FFR manual doesn't even acknowledge them and all searches on the forum pulled up blanks.

Any help would be greatly appreciated.

129560

[michael everson]

You don't need any of them. The 12 volt key on is for 12 volt output for any options you might want to add. Not needed either.
Mike

[flip1216]

Mike,

Thanks for the quick reply.

- Flip