Breeze lighting quick disconnect questions

[nick7405]

I am wiring up the quick disconnect for the lights and have some questions. Each front corner has 5 wires,

Hi beam, brown
Lo beam, red
Ground black
Turn blue
Park tan


My question is for the head lamp I wire the hi beam, lo beam, ground to the connector and to the turn signal i wire the park and turn?

Lastly there isn't a ground going to the turn signal so I'm assuming I splice the ground wire going to the headlight and route the wire to the turn signal so the will have three wires now? Turn, park and the new ground?

[jrcuz]

Hi Nick, I'm using them also and that is what I did with the grounds.
JR

[D Stand]

You are correct Nick.

[nick7405]

Thanks guys, that is out of the way, next question is for the rear, I was going to get started on the rear but in the box I found the converter box which just confused me.. whats the convert box for?

[BradCraig]

Thanks guys, that is out of the way, next question is for the rear, I was going to get started on the rear but in the box I found the converter box which just confused me.. whats the convert box for?

It's to convert the 4 wire harness to the new 3-wire tail lights. I didn't even think about that converter until last weekend. I've already buttoned up all my aluminum and chassis harness, so should be interesting getting it installed. Not sure where to install it as there is zero docs for this. My assumption as right before the "Y" in the rear chassis harness. definitely open to suggestions from the group.