Aluminium Panels

[Grusks]

Just fitting the last few panels before i put the body on


I have a Gen 2 Chassis

I cant workout the how the door strike panels go for my chassis and also missing a few panels by th elook of it ( empty 16A box )


Any pictures guys of how the strike panels fit to the chassis as it doesn't match any of the angles of the frame
128885
128886


and what panels fit in these gaps by your feet again any pictures would be great as need to make something for both sides
128887

[rapidray]

I also could not figure out how those 2 panels go! I tried them every which way I could and they made no sense to me at all. According to the instructions in the on-line manual 3E page 287 you are supposed to get 2 panels to cover the gaps in the front but my Gen 2 kit did not contain any nor could I find them on the inventory sheet so I just made my own. If you figure out the placement of those panels by the striker please let me know! Ray

[JimLev]

The panel your holding goes up under the dash. The part your holding goes mounts vertical on the side of the frame. From the looks of it they go above the striker.
It's shown on page 424 in my Gen 1 manual.

[Grusks]

The panel your holding goes up under the dash. The part your holding goes mounts vertical on the side of the frame. From the looks of it they go above the striker.
It's shown on page 424 in my Gen 1 manual.

Hi Jim

Think the Gen chassis is slightly different, as both strike brackets welded to the chassis are moved inward 5mm ( you can just make it out on my picture ) so wont allow it to sit on my chassis rails

Spence

[House Money]

I think you are looking for these panels: #34381 Cockpit front outside corner, left, and #34382 same but for right side.

Gary

[AJT '33]

I covered mine in sprayable rubber as my feet are going to hit them. They cover the brackets.
128963 128964