Gas pedal problems

[Mike Garrett]

The gas pedal for the Coyote motor, after modification as per FFR, will not mount. I installed the FFR gas pedal mount and it lined up with holes but when I went to mount the pedal to the bracket it hit one of the cross members for the support member. It seems if I would reduce the spacing between the firewall and the pedal mount bracket it would work okay. I have a new Mark 4 with Coyote engine.

[BEAR-AvHistory]

Think you have it up too high hard to tell from your picture. The look at the round hole - the mount should be below that if it's the same as a GenI

https://thefactoryfiveforum.com/attachment.php?attachmentid=125589&d=1585966778

See if you can line up one of the bottom holes on the bracket with this plate.

https://thefactoryfiveforum.com/attachment.php?attachmentid=125591&d=1585968079

[Mike Garrett]

Thanks, I’ll give it a try.

[BEAR-AvHistory]

Better shot took it this morning.

https://thefactoryfiveforum.com/attachment.php?attachmentid=125688&d=1586103805