Gauge Pod fit for Dash

[mrbiglar]

Has anyone else had trouble with the fit for the gauge pod to the dash? I have a good 1/4" in the middle of each side. Am assuming I have to trim down, but cutting the dash sucks as it tends to melt and fray.

Thoughts?

Tried two different pods I have.

Thanks in advance for help

119798

119799

[STiPWRD]

I believe I did some slight trimming of that area and a little contouring with a heat gun to better fit the shape. Seemed to go fairly smooth, the fraying can be easily cleaned up by sanding the edges. Most FFR fiberglass and dash panels require a little trimming.

[aquillen]

FYI a multi-tool or versa-tool (left-right vibrating blade) type cutter works pretty well for trimming this material. I use a Dewalt battery one that has speed control, at lower speeds it cuts well with minimal melting problem.

[20boxer]

that's what mine looks like. You can't tell when your staring at it from the drivers seat. I was going to make a small trim piece to throw a shadow on it

[Newkitguy]

mine also fits like ****, i just chalked it up as the lackluster interior. I'm really thinking through the improvements i'm going to make to the interior just not sure yet.