View Full Version : Looking for plug and pin kit
Shoeless
12-24-2019, 09:50 PM
Hey guys,
I've done some looking but am having trouble locating a plug and pin set for the plug that goes into the in tank fuel pump setup pictured below. I have the Lingenfelter high-flow pump, but should be the same as the OEM connector.
Anybody know where I can source one of these plug and pin sets?
https://i.imgur.com/NAwkhoC.jpg
wallace18
12-25-2019, 07:08 AM
online Corvette salvage yards will have it.
https://corvettesalvage.com
beeman
12-25-2019, 10:08 AM
Not sure, this Fuel Pump Adapter Harness (FPAH-001) by Racetronix looks like the same pigtail...
https://www.carid.com/images/racetronix/items/fpah-001-3.jpg
Shoeless
12-25-2019, 10:51 AM
Not sure, this Fuel Pump Adapter Harness (FPAH-001) by Racetronix looks like the same pigtail...
https://www.carid.com/images/racetronix/items/fpah-001-3.jpg
That looks darn close, I'll have to give them a call and double check. If this one actually fits, it looks like it's a GM Delphi / Packard - 4 way square metripack 150 male O2 connector Kit. Found it on Ballinger Motorsports for $6.99 after reading the details on the Racetronix website.
https://www.bmotorsports.com/shop/product_info.php/products_id/868
This is what you need.
https://www.racetronix.biz/product.asp?ic=iph-008.
I think The metripack 150 is too small, is is closer to 280 than 150 due to higher current needs.
Shoeless
12-25-2019, 01:29 PM
This is what you need.
https://www.racetronix.biz/product.asp?ic=iph-008.
Now that looks exactly like the plug that goes from the internal flange side to the pump itself. I just took it apart again to verify and sure enough that's the plug on the inside. Now I just need to source some new pins. Thanks for the help KGTM!!
https://i.imgur.com/AspKnoI.jpg
https://i.imgur.com/M9flClg.jpg
https://i.imgur.com/dggFThq.jpg
no problems.
I used the OEM cable just pictures and source the mating end that it is easier to get.
119442119443
HardRocker
12-29-2019, 09:14 AM
Powerandsignal.com and mouser electronics have the pins and plugs. One of the C5 manuals will spec the connector and pin type.