View Full Version : Wiring question, Ron Francis harness head/tail lights
TheDon
12-22-2019, 08:51 PM
Hi guys, I am go carting and now putting the body on to finish fit everything, I already tested all the lights etc with just a bulb on leads, but now that im looking to install the head/tail lights etc I see the harness has nice connectors but I dont remember having the other gender connector. I have the complete kit w the Ron Francis harness. Are we supposed to cut and splice the lgihts onto the wires or do I have the connectors hidden somewhere in the garage?
119344119346119347
Those must be new for the RF harness. All mine were just blunt cut wires and I installed Weatherpak connectors on all of mine.
MSumners
12-22-2019, 10:53 PM
Same as Papa, installing weatherpacks.
Where is that rod end?
TheDon
12-25-2019, 08:38 PM
The rod end pic is the hinge for the front end. My kit is a 2009 so maybe not new but old lol. I guell ill check the connectors for part numbers and see if i can buy the other side to make a clean connection.
Thanks guys.
edwardb
12-26-2019, 08:45 AM
Your best bet is to cut those off and install two 3-cavity Weatherpacks on each corner. Even if you could find mating connectors, you'd have to wire with two lights going into a single connector. Meaning you can't get the lights out of the body once wired. Not too great.
TheDon
12-30-2019, 10:54 AM
Good news I found the connectors stored in the wrong place. So for the record RF harness does come with them. Ill use them so I can disconnect the front clip.
I had the hood/clip all aligned and trimmed then stored it. Now putting it back on i had to fight it for an 8 hr day. I cant imagine doing all this again with a painted body, and just minor trimming and sanding has got fiberglass dust everywhere even using a shop vac and fan.
I thought I was mostly done, HA!
119677