MaxJax 2-post Lift Spacing Recommendation

[KauaiMK4]

Hello,

Question for those who have the MaxJax lift:

What is your recommendation for spacing of the posts for the MK-4?

Primarily will be used for the MK4 but other vehicles I have for lifting are a Kia Optima and Toyota Tacoma.

Thanks,

Leland
KauaiMK4

[Ponymedic]

I just installed 105 to the outside of plates for my roadster and it seemed ok. I did have an issue with hight clearence to sidepipes. I would up with the 3 inch extensions on the arms and rolling the car onto 2 2x4s

[progmgr1]

Mine are also set at 105" to the outside of the bottom plates. This is very tight for my '33 Hot Rod with full fenders and running boards. I haven't tried it yet, but I suspect that a full sized vehicle would also be a very tight fit. If your garage layout allows, I suggest going 6-12" wider or more. That will make getting a vehicle in and out much easier. Keith HR#894

[KauaiMK4]

Thank you for the recommendations.

I am planning to try setting up at 120 inches and see how that works!

[flynntuna]

One good thing about the Max Jax is that you can always get more concrete anchors to make it wider to accommodate wider cars.