View Full Version : Coyote Fuel line quick disconnect connectors
magicmarto
10-24-2019, 12:36 PM
Hello All,
I am using a high pressure rubber hose that is steel reinforced and has a braided cover on it for my Coyote build.
3/8" on both the fuel filter and motor quick disconnects-
ID of the hose is 5/16"
I want to use the push on quick disconnects on both ends.
Any suggestions or links to the correct ones to get?
PS- I am also planning on using HP fuel injection hose clamps too.
Thanks for the inputs.
Martin
Where is your fuel pressure regulator? Is it at the pump or in the engine bay? I'm trying to understand where you want to have quick disconnects. Are you running a line from the filter directly to the fuel rail?
Mark Reynolds
10-25-2019, 08:47 PM
Life would be way easier if you could go to 3/8" ID Hose. Any chance of up-sizing?
magicmarto
10-26-2019, 08:58 AM
No Pressure regulator-I am using a pre set pressurized fuel filter from Mike Forte(about 55psi)this filter also has a built in return line to the fuel tank. I think it from corvette fuel system. So one fuel line, running from the pressurized fuel filter to the fuel rail on the motor.
totem
10-26-2019, 10:32 AM
Look at these:
https://www.summitracing.com/int/search/brand/dorman/product-line/dorman-fuel-line-connectors?SortBy=BestKeywordMatch&SortOrder=Ascending
Find the right hard line quick connect diameter and the right hose diameter.
R.
Life would be way easier if you could go to 3/8" ID Hose. Any chance of up-sizing?
I agree with Mark. The Dorman connectors that Totem identified work well.
magicmarto
10-27-2019, 08:13 AM
Bingo
Thanks guys
I am running a -6AN(.340" ID) fuel line. I am guessing that is a 3/8" ID fuel line?
https://www.lefthanderchassis.com/v2a/16_viewproduct_group.asp?idgroup=2513530
Martin