ABS speed sensor - how to route around suspension components?

[shackf16]

I'm nearing the end of my complete rewiring project that included adding a 3-channel ABS setup from a 95 Mustang GT. I have the ABS module installed on the PAX side in front of the engine. I have the 4 wheel speed sensors attached to the stock mounting points at the front and rear (using 94/95 spindles and solid axle) but I'm having a hard time figuring out the best way to route the individual speed sensor wiring harnesses around the suspension at both ends. There is enough harness from the donor to clear the suspension and then I'll add the extra (twisted pair) wiring to get to the ABS module.

So who has already done this and how did you route the wiring? I will use the front mounting bracket to hold it to the spindle, but I don't have anything as convenient for the rear. Where should I "jump" from the spindle to the frame? Same for the rear...

Thanks!
Shack

113899113900