jdavis500
09-06-2019, 09:49 AM
A while back, I bit the bullet and ordered some custom badges for my build. They were quite expensive, but I felt it was a good bang for the buck because they are so professional looking and immediately seen. I ordered 3. One for each fender in the typical decal location(curve to match the contour) and one for the dash. The fender badges have 3M tape on them and the dash badge is tapped for screws so there will be a little dimpling in the dash vinyl. I adapted the design from the decal design with a trim here and a tuck there. There is a limit to the billet process when it comes to tight gaps. Billet Badges makes high-quality products, but the turnaround time was about 5 months. I shopped around to have this made in chromed plastic. People were reluctant to do small batches. 50 was about the least I could order. They were in the same price range for 50, but I wasn't sure if they would really pop. No problem with the polished steel.
113838
113838