Asymmetric Gen 3 Coupe side windows

[jdavis500]

Just checking to see if anyone has had the same experience. I recently received my side windows and have found that they are very asymmetric. The height of the windows outside edge to outside edge vary by 3/8"(12 1/4" and 11 7/8"). The lower part of the trapezoid varies as well. 1 1/2" on the passenger side and 3/4" on the driver side. The length from lower corners varies by 1/2". I placed tape on these to prevent damaging the powder coat.

113441

[edwardb]

You're assuming the body and doors are perfectly symmetrical. Which in my experience are not. :p Obviously can't say for sure, but when you try them with the doors installed I bet you'll find they fit OK. Mine did.

[Erik W. Treves]

you wont notice that when you are done, mine fit fine.

[Chris @ Forma]

I haven't used the FFR windows, however, I am in the process of developing a roll up window solution, we scanned both sides of our coupe and they are substantially different. We designed for the driver side. then 3 D printed parts to check fit. We also printed a mirror image for the passenger and low and behold...they don't fit.

115357