View Full Version : No power?
chuckster
08-13-2019, 06:51 PM
Well I’m stumped. Car wouldn’t start, seems the cheap battery wouldn’t hold a charge. Bit the bullet, bought an Odessey yellow top, putting out 13.6 volts. Try and start the car cranks for maybe 1/2 a rev, and then nothing, and I mean NOTHING. No cranking, no instruments, no lights, no horn, nothing. Power at the battery, power at the positive distribution block. Any thoughts or suggestions would be appreciated.
mike223
08-13-2019, 07:15 PM
Well I’m stumped. Car wouldn’t start, seems the cheap battery wouldn’t hold a charge. Bit the bullet, bought an Odessey yellow top, putting out 13.6 volts. Try and start the car cranks for maybe 1/2 a rev, and then nothing, and I mean NOTHING. No cranking, no instruments, no lights, no horn, nothing. Power at the battery, power at the positive distribution block. Any thoughts or suggestions would be appreciated.
You've got a bad connection somewhere - breaking down under high amperage load.
Especially watch the negative side too - depending on where the battery is, it make take two or three people + 6'-10' meter leads to isolate the problem(s?).
65 Cobra Dude
08-13-2019, 07:23 PM
Chuck,
As Mike eluded to above, check your grounds. Do you have a ground from the engine block to the frame? How long is the negative cable from the battery to the frame? Did you grind away the powdercoat wherever you have a ground connection?
Thx,
Henry
chuckster
08-14-2019, 08:16 PM
Thanks folks, bad solder joint on the block to frame ground cable.
Now that you've solved the problem, I don't need to start at the top of the typical troubleshooting list...
"Is it plugged in?"
:p
Glad you got it resolved.
Dave
Jennitran
08-22-2019, 12:28 AM
Thanks folks, bad solder joint on the block to frame ground cable.Visit this link (https://autofthings.com/best-battery-maintainer/) to find the best battery tender that you may concern.
Glad to hear you solved this problem.